Recording Voice Intros for DJs
Updated October 2026
A voice intro for a set or a show has to cut through music and sound sharp in a short clip. A close mic, a level that stands out and a clean take make an intro work.
The short version
- A close mic and a dry room give a sharp intro.
- Set the level so the voice sits above the music without clipping.
- Record the intro against the tempo, so the timing lines up.
- Clean each drop gently and keep the takes.
The mic and the room
A close mic in a dry room gives a sharp, present voice. Soft furnishings keep the echo down, so the voice sits well on top of the music.
Level and timing
Set the level so the voice stands out from the music without clipping. Record against the tempo of the set, using the BPM finder to find it, so the words land on the beat.
Clean the drops
Clean each drop with gentle settings and check the loudness against the rest of the set. Keep the takes so you can swap them later.
Sharp intros, clean drops
Tunedzy cleans each intro and sets it to a level that sits well with the music.
Free tools for this
Frequently asked questions
How loud should an intro be?
Loud enough to cut through the music, and below clipping. Test it with the set.
Should I match the tempo?
Yes, where the words land on the beat. The BPM finder helps.
Can I use a phone?
Yes, close to the mouth in a dry room.
Keep going
How to Make a Podcast Intro and OutroHow to Duck Music Under a Voiceover
How to Record a Voicemail GreetingAll guides and comparisons · Tunedzy Go on your phone · Pricing